Pro-Form 860 User Manual page 6

ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires your own Phillips screw-
driver (_,==,===- and rubber mallet c:::::::::::_.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping,a
small amount of lubricantmay be transferredto the top of the walking belt or the shippingcarton. This is a normal
conditionand does not affect treadmill performance. If there is lubricanton top of the walking belt, simply wipe off
the lubricantwith a soft clothand a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
treadmill to the uprightposition as shown.
Insert one of the Extension Legs (55) intothe treadmillas
shown. Make sure that the Extension Leg is turned so
the Base Pad (44) is on the bottom. If necessary, tip the
Uprights (64) forward as you insert the Extension Leg.
Insert the other Extension Leg (not shown) in the same
way.
44
2. With the help of a second person, carefully lower the
Uprights (64) as shown. Note: It may be helpfulto place
your foot on the Wheel (58) as you tip the Uprights.Make
sure that the Extension Legs (55) remain in the
Uprights.
Attach each Extension Leg (55) with two Extension
Screws (35) as shown.
Note: One replacement Base Pad (44) may be included.
If a Base Pad becomes worn and needs to be replaced,
use the replacement Base Pad.
55
35