Download Print this page

Pro-Form 860 User Manual page 23

Hide thumbs Also See for 860:

Advertisement

TROUBLE-SHOOTING
Most treadmill problems can be solved by following the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assistance is needed, call our toll-free HELPLINE at
1-800-736-6879, Monday through Saturday, 7 a.m. until 7 p.m. Central Time (excluding holidays).
PROBLEM:
The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor,and that the surge suppressor
is plugged into a properlygrounded outlet (see page 8). Use only a single-outletsurge suppressor
that meets all of the specificationsdescribedon page 8. Important:The treadmillis not compatible
with GFCI-equipped outlets.
b. After the powercord has been plugged in, make sure that the key is fullyinserted intothe console.
c. Check the circuitbreaker located on the treadmill
near the power cord. If the switch protrudesas
shown, the circuitbreaker has tripped. To reset the
circuit breaker, wait for five minutes and then press
the switch back in.
d. Check the on/off switch located on the treadmill near
the power cord. The switch must be in the on posi-
tion.
c
Tripped
Reset
Tripped
RA._At
On J
Position
PROBLEM: The power turns offduring use
SOLUTION: a. Check the circuitbreaker located on the treadmillframe near the power cord (see c. above). If the
circuit breaker has tripped, wait for five minutesand then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Unplug the power cord, wait for five minutes, and then plug the power cord back in.
d. Remove the key from the console. Reinsert the key fully into the console.
e. Make sure that the on/off switch is in the on position.
f. If the treadmill stillwill not run, please call our toll-free HELPLINE.
PROBLEM: The speed display on the console does not function properly
SOLUTION: a. Remove the key and UNPLUG THE POWER CORD.
Carefully lower the Uprights (64) to the floor. Remove
the three indicated Small Screws (37).
Raise the Uprights (64) to the vertical position. Pivot
the Hood (1) off.
37
23

Advertisement

loading
Need help?

Need help?

Do you have a question about the 860 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

831.299580