Omtech SH-F50 User Manual page 6

1.3 Designated Use
This machine is intended for engraving signs and logos on consumer products or applicable substrates, for commercial or
industrial use ONLY. This laser can process a wide variety of metals including steel, aluminium, titanium, brass, copper,
tungsten, carbide, and chrome. It can also be used with stone and some hard plastics such as acrylic. (See §§2.5 & 4.3 for
further details.) Use of this system for non-designated purposes or materials is not permitted.
The system must be operated, maintained, and repaired by personnel familiar with the field of use and the dangers of the
machine and the material being engraved including its reflectivity, conductivity, potential for creating harmful or
combustible fumes, etc.
Laser beams are dangerous. The manufacturer and/or seller bear(s) no responsibility and assume(s) no liability for any
improper use of this device or for any damage or injury arising from such use. The operator is obliged to use this fiber
laser marker only in accordance with its designated use, the other instructions on the device and in its manuals, and all
applicable local and national laws and regulations.
1.4 Technical Specifications
Model
Input Power
Rated Power
Expected Service Life
Laser Wavelength
Laser Frequency
Processing Area
Max. Marking Speed
Min. Marking Depth
Max. Marking Depth
Min. Line Width
Precision
Required Operating Environment
Required Operating Software
SH-F50
220V/50Hz
50W
100,000 hr.
1064 nm (1.064 µm)
50–100 kHz
30×30 cm (11.8×11.8 in.)
700 cm/s (275.6 ips)
0.005 mm (0.0002 in.)
0.1 mm (0.004 in.) on a single pass
0.15 mm (0.006 in.)
±0.1 µm
<70% Humidity and 5–35°C (40–95°F)
EZCad
2