Projecta INTELLI-RV Instruction Manual page 2

IMPORTANT SAFETY INFORMATION
Please read this manual thoroughly before use and store in a safe place for future reference.
WARNINGS
• Explosive gases. Prevent flames and sparks. Provide adequate ventilation during charging
• Before charging, read the instructions
• For indoor use ONLY.
• For charging lead acid and LiFePO4 batteries ONLY (of the size & voltage specified in the
specifications table)
• Always charge the battery on the correct voltage setting. Never set the charger to a higher
voltage than the battery specifications state
• Disconnect the 240V mains supply before making or breaking the connections to the battery
• Connect the positive battery terminals before making any ground connections. The ground
connection to the chassis should be made away from the battery and any fuel line. Only
connect mains after the battery is connected.
• The battery charger must be plugged into an earthed socket outlet
• Connection to supply mains is to be in accordance with national wiring rules
• Do not attempt to charge non-rechargeable batteries
• Never charge a frozen battery
• If AC cord is damaged, do not attempt to use. Replace with a compatible earthed IEC cable
immediately.
• Corrosive substances may escape from the battery during charging and damage delicate
surfaces. Store and charge in a suitable area
• This charger is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use of the appliance by a person responsible
for their safety
• Children being supervised not to play with the appliance
• If the recreational vehicle is to be put into storage without power, please turn off the BATTERY
MASTER SWITCH. If the recreational vehicle is to be stored for 3 months or longer, it's
advisable to disconnect all fuses from the battery. A full charge should be run every 3 months.
2