Standards Applied - Elma Instruments iTest 7400 Manual

2.5 Standards applied

The Elma iTest 7400 is manufactured and tested in accordance with the following regulations:
Electromagnetic compatibility (EMC)
Electrical equipment for measurement, control and laboratory use – EMC requirements
EN 61326
Class B (Hand-held equipment used in controlled EM environments)
Safety (LVD)
Safety requirements for electrical equipment for measurement, control and laboratory
EN 61010-1
use – Part 1: General requirements
EN 61010-031 Safety requirements for hand-held probe assemblies for electrical measurement and test
Functionality
Electrical safety in low voltage distribution systems up to 1000 VAC and 1500 VAC –
EN 61557
Equipment for testing, measuring or monitoring of protective measures
Part 1 General requirements
Part 2 Insulation resistance
Part 3 Loop resistance
Part 4 Resistance of earth connection and equipotential bonding
Part 6 Residual current devices (RCDs) in TT and TN systems
Part 7 Phase sequence
Part 10 Combined measuring equipment
EVSE
Residual direct current detecting device (RDC-DD) to be used for mode 3 charging of
IEC 62955
electric vehicles
Note about EN and IEC standards:
Text of this manual contains references to European standards. All standards of EN 6XXXX (e.g. EN 61010)
series are equivalent to IEC standards with the same number (e.g. IEC 61010) and differ only in amended
parts required by European harmonization procedure.
Elma iTest 7400 Multifunction tester
8