SCIFIT PRO1 Series Owner's Manual page 22

Rowing Motion
Customers may use a feature of the PRO1 called the "Rowing Motion". This will require the right crank and handle to
be repositioned in the same direction as the left. The following steps with show how this is done.
TOOLS REQUIRED:
• 5/32" (4 mm) Allen Hex Wrench
1. Use the 5/32" allen wrench to remove the screws and washers on the ends of the two right side crank rods, then
place them to the side
2. Firmly grab the right crank, then pull the yellow adjustment knob outward allowing the crank to be removed from
the hub.
Page 20 of 26