Download Print this page

Aiwa NSX-MT725 Operating Instructions Manual page 27

Aiwa compact disc stereo system operating instructions mt-725

Advertisement

Available languages

Available languages

1
2
ADDITIONAL
DOLBY PRO LOGIC MODES
In addition to the NORMAL mode, this unit is also equipped with
the PHANTOM and the 3 STEREO modes.
'"8
u
Press VIDEO/AUX and start playback of the video
source.
"VIDEO" is displayed,
Press DOLBY PRO LOGIC.
"NORMAL" is selected, and the playback sound has the
DOLBY PRO LOGIC effect.
To cancel DOLBY PRO LOGIC mode
Press DOLBY PRO LOGIC repeatedly
until "PRO-OFF"
is
displayed.
To change the sound levels during
playback
After adjusting the balance with the noise sequencer, the sound
levels of the center or each surround speaker can be adjusted
during playback of laser discs or video software.
1 Press MANUAL SELECT on the remote control repeatedly
to select "CEN" (center speaker) or "SUR (surround speakers).
2 While the "CEN" or "SUR is displayed, press +
DOWN or
B+ UP on the remote control to adjust the volume.
PHANTOM mode: Use this mode when no center speaker is
connected. The center channel signals are output through the
left and right speakers.
3 STEREO mode: Use this mode when no surround speakers,
are connected. This mode reproduces rear sounds through the
front speakers.
To select PHANTOM or 3 STEREO
Press DOLBY PRO LOGIC repeatedly until the desired DC)LBY
PRO LOGIC mode is displayed. The DOLBY PRO LOGIC mode
is displayed cyclically as follows.
r
NORMAL -+
PHANTOM+
3 STEREC) --l
~
PRO-OFF (cancel)
I
To adjust the balance of connected speaker sound levels,
Carry out steps 2 to 4 of "ADJUSTING
SPEAKER
LEWEL.
BALANCE",
m
Depending on the sound source and/or listening conditions,
al
surround effect may not be obtained even when the DOLBY
PRO LOGIC is on,
The full DOLBY PRO LOGIC effect cannot be obtained wherl
using software without DDIDD~Y S UUUUUNDI
mark. In this case, use
the SURROUND system instead. (See page 16.)
The DOLBY PRO LOGIC is automatically canceled when:
- the ECHO level is changed.
- the SURROUND system or the BBE is turned on.
- the headphones are plugged in.
- the Karaoke function is turned on.
Set the microphone volume to OFF while the DOLBY PRCI
LOGIC is on. Otherwise, the DOLBY PRO LOGIC sound car
not be reproduced correctly,
ENGLISH
27

Advertisement

loading