Aiwa NSX-MT725 Operating Instructions Manual page 25

5~
CD EDIT/CHECK
~
1
l—
Jd
'""u
"4,5
In the programmed edit recording function the tracks can be
programmed while checking the remaining time on each side of
the tape.
m
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded on from the beginning of
either side,
1
2
3
4
5
Insert the tape into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
Press CD and load the disc(s).
Press CD EDIT/CHECK twice.
"EDIT" and "PRGM" are displayed.
* When "Al" is displayed, press CD EDIT/CHECK again.
Press numbered buttons on the remote control
to designate the tape length.
10 to 99 minutes can be specified,
* The ++, FP or MULTI JOG are also available to designate
the tape length.
Tape length Tape side A (front side)
Maximum recording
time for side A
Press DISC DIRECT PLAY 1-3 to select a disc.
Then, press numbered buttons O-9 and +10 on
the remote control to program a track.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY 2, then press +10 and O.
Remaining time Programmed
Selected track number
on side A
tracks
6
7
8
Repeat step 5 for the rest of the tracks for side! '"".
A.
a
$: "$
~.-.'J -
A track whose playing time is longer than the remaining time
~~j:
cannot be programmed.
j::~:;
8
,.. :.:
::!
,,,,.? "!!: :
Press CD EDIT/CHECK to select side B andl !w~
program the tracks for side B.
'g
After confirming "B" on the display, repeat step 5.
Tape side B (reverse side)
Press REC/REC MUTE to start recording.
The tape is rewound to the beginning of the frcmt side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front side (A) ends, recording
on the back side (B) starts.
To stop recording
Press . Recording and CD play stop simultaneously.
To
check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK to select side A or B,
and press + or * repeatedly.
Programmed track
Disc number
Track number numbers
Tape side
Program number
To change the program otf each side
Press CD EDIT/CHECK to select side A or B, and press
CLEAR to clear the program cmthe selected side. Then program
tracks again.
To clear the edit program
Press CLEAR twice so that "EDIT disappears on the display
Up to 30 tracks can be programmed from any of IIhe insertecl
discs.
* "FUL~ is displayed if you attempt to program more than 3CI
tracks.
Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off,
Program number
ENGLIStf
2:)