Digital Control DIGITRAK FALCON F2+ User Manual page 44

CHANGE BANDS
STEP 1 OF 4
Stuff you should know
Switching bands on the transmitter may provide better data, better depth,
and/or better locate results as interference conditions change.
Calibrate BOTH bands before drilling so you get accurate depth
readings on both bands.
STEP 2 OF 4
Observe signal strength drop after the drill operator completes a roll
sequence to change bands.
When using a wideband transmitter and the 10-2-7 roll
sequence, transmitter data will disappear after a successful
band change.
STEP 3 OF 4
From the Locate Mode screen, hold toggle right to open the Band Selection
shortcut menu.
DIGITAL CONTROL, INC
DIGITRAK FALCON F2+
DCI DigiGuide
USER MANUAL
05.18.2024
44