Replacing The Number Plate Light Bulb - APRILIA RSV 1000 R FACTORY Manual

CAUTION
On refitting, ensure that the lens locates
properly into its slot. Tighten the screw
(1) gradually. Do not overtighten or the
shield will damage.
Push down the bulb (3) gently and twist
u
anti-clockwise.
Extract the bulb (3) from its seat.
u
CAUTION
When fitting the bulb, ensure that the
two locating pegs locate properly into
the slots in the bulb holder.
Install a new bulb of equal rating.
u
108
use and maintenance RSV 1000 R - RSV 1000 R FACTORY
1
CAUTION
If the reflector (4) comes off its seat,
refit it correctly.
REPLACING THE NUMBER PLATE
LIGHT BULB
Read page 105 (BULBS) carefully.
Place the vehicle on the stand, see page
u
58 (PLACING THE VEHICLE ON THE
STAND).
Remove the passenger seat / glove/tool
u
kit compartment cover, see page 29
( U N L O C K I N G / L O C K I N G
GLOVE/TOOL KIT COMPARTMENT
COVER).
4
3
5
Never pull on the wiring to extract a
bulb holder.
Extract the number plate light bulb holder
u
(5).
Remove the bulb and fit a new one with
u
equal rating.
NOTE
Ensure that the bulb locates
correctly into the bulb holder.
T H E
CAUTION