Changing The Rear Light Bulb; Changing The Number Plate Bulb - APRILIA LEONARDO 125 - 2006 Manual

Leonardo125-300_UK.book Page 64 Tuesday, January 20, 2004 3:54 PM
CHANGING
THE REAR LIGHT BULB
Carefully read p. 62 (BULBS).
The rear light contains:
√ A parking light/stoplight bulb (1).
√ Two rear direction indicator bulbs (2).
To change them:
Loosen the screws (3) in such a way as
to facilitate the successive reinsertion of
the protection screen (4).
Unscrew and remove the screws (5).
! CAUTION
While removing the protection screen,
proceed carefully in order not to break
the cog.
64 use and maintenance Leonardo 125 - 150 - 250 - 300
Remove the protection screen (4).
Slightly press the bulb and rotate it
anticlockwise.
Remove the bulb from its seat.
NOTE
Insert the bulb in the socket,
making the two bulb pins coincide with the
relevant guides on the socket.
Correctly install a new bulb of the same
type.
NOTE
Upon reassembly, correctly
position the protection screen in its seat.
!
CAUTION
Tighten the screws (5) carefully, without
exerting too much pressure, in order to
avoid damaging the protection screen.
CHANGING THE NUMBER PLATE
BULB
Carefully read p. 62 (BULBS).
To change the bulb:
Unscrew and remove the screw (6).
Remove the light unit (7).
!
CAUTION
Do not pull the electric wires to extract
the bulb socket.
Grasp the bulb socket (8), pull it and
remove it from its seat.
Withdraw the bulb (9) and replace it with
a new one of the same type.