ZyXEL Communications ZYWALL - CLI Reference Manual page 72

Chapter 6 Interfaces
Table 28 Cellular Status
STATUS
PPP fail
Need auth-password
Device ready
6.6.2 Cellular Interface Command Examples
This example shows the configuration of a cellular interface named cellular2 for use with a
Sierra Wireless AC850 3G card. It uses only a 3G (or 3.5G) connection, PIN code 1234, an
MTU of 1200 bytes, a description of "This is cellular2" and sets the connection to be nailed-
up.
Router(config)# interface cellular2
Router(config-if-cellular)# device AC850
Router(config-if-cellular)# band wcdma
Router(config-if-cellular)# pin 1234
Router(config-if-cellular)# connectivity nail-up
Router(config-if-cellular)# description This is cellular2
Router(config-if-cellular)# mtu 1200
Router(config-if-cellular)# exit
This second example shows specifying a new PIN code of 4567.
Router(config)# interface cellular2
Router(config-if-cellular)# pin 4567
Router(config-if-cellular)# exit
This example shows the 3G and SIM card information for interface cellular2 on the ZyWALL.
Router(config)# show interface cellular2 device status
interface name: cellular2
extension slot: USB 1
service provider: Chunghwa Telecom
cellular system: WCDMA
signal strength: -95 dBm
signal quality: Poor
device type: WCDMA
device manufacturer: Huawei
device model: E220/E270/E800A
device firmware: 076.11.07.106
device IMEI/ESN: 351827019784694
SIM card IMSI: 466923100565274
72
DESCRIPTION
The ZyWALL failed to create a PPP connection for the cellular interface.
You need to enter the password for the 3G card in the cellular edit screen.
The ZyWALL successfully applied all of your configuration and you can use the
3G connection.
ZyWALL (ZLD) CLI Reference Guide