ZyXEL Communications ZYWALL - CLI Reference Manual page 52

Chapter 6 Interfaces
Table 16 interface General Commands: Basic Properties and IP Address Assignment (continued)
COMMAND
[no] description description
[no] downstream <0..1048576>
exit
[no] ip address dhcp
[no] ip address ip subnet_mask
[no] ip gateway ip
ip gateway ip metric <0..15>
[no] metric <0..15>
[no] mss <536..1460>
[no] mtu <576..1500>
[no] shutdown
traffic-prioritize {tcp-ack|content-
filter|dns|ipsec-vpn|ssl-vpn} bandwidth
<0..1048576> priority <1..7> [maximize-
bandwidth-usage];
traffic-prioritize {tcp-ack|content-
filter|dns|ipsec-vpn|ssl-vpn} deactivate
[no] upstream <0..1048576>
52
DESCRIPTION
Specifies the description for the specified interface.
The no command clears the description.
description: You can use alphanumeric and
characters, and it can be up
()+/:=?!*#@$_%-
to 60 characters long.
This is reserved for future use.
Specifies the downstream bandwidth for the
specified interface. The no
downstream bandwidth to 1048576.
Leaves the sub-command mode.
Makes the specified interface a DHCP client; the
DHCP server gives the specified interface its IP
address, subnet mask, and gateway. The
command makes the IP address static IP address
for the specified interface. (See the next command
to set this IP address.)
Assigns the specified IP address and subnet mask
to the specified interface. The
the IP address and the subnet mask.
Adds the specified gateway using the specified
interface. The no command removes the gateway.
Sets the priority (relative to every gateway on every
interface) for the specified gateway. The lower the
number, the higher the priority.
Sets the PPPoE/PPTP or cellular interface's priority
relative to other interfaces. The lower the number,
the higher the priority.
Specifies the maximum segment size (MSS) the
interface is to use. MSS is the largest amount of
data, specified in bytes, that the interface can
handle in a single, unfragmented piece. The
command has the interface use its default MSS.
Specifies the Maximum Transmission Unit, which is
the maximum number of bytes in each packet
moving through this interface. The ZyWALL divides
larger packets into smaller fragments. The
command resets the MTU to 1500.
Deactivates the specified interface. The
command activates it.
Applies traffic priority when the interface sends
TCP-ACK traffic, traffic for querying the content
filter, traffic for resolving domain names, or
encrypted traffic for an IPSec or SSL VPN tunnel. It
also sets how much bandwidth the traffic can use
and can turn on maximize bandwidth usage.
Turns off traffic priority settings for when the
interface sends the specified type of traffic.
Specifies the upstream bandwidth for the specified
interface. The command sets the upstream
no
bandwidth to 1048576.
ZyWALL (ZLD) CLI Reference Guide
command sets the
no
command clears
no
no
no
no