ZyXEL Communications ZYWALL - CLI Reference Manual page 65

Table 24 Basic Interface Setting Commands (continued)
COMMAND
[no] negotiation auto
[no] speed <100,10>
show port setting
show port status
6.3.2.1 Port Grouping Command Examples
The following commands add physical port 5 to representative interface ge1.
Router# configure terminal
Router(config)# show port-grouping
No. Representative Name
=========================================================
1 ge1
2 ge2
3 ge3
4 ge4
5 ge5
Router(config)# port-grouping ge1
Router(config-port-grouping)# port 5
Router(config-port-grouping)# exit
Router(config)# show port-grouping
No. Representative Name
=========================================================
1 ge1
2 ge2
3 ge3
4 ge4
5 ge5
The following commands set port 1 to use auto-negotiation auto and port 2 to use a 10 Mbps
connection speed and half duplex.
Router(config)# port status Port1
Router(config-port-status)# negotiation auto
Router(config-port-status)# exit
Router(config)# port status Port2
Router(config-port-status)# duplex half
Router(config-port-status)# speed 10
Router(config-port-status)# exit
Router(config)# exit
ZyWALL (ZLD) CLI Reference Guide
DESCRIPTION
Sets the port to use auto-negotiation to determine
the port speed and duplex. The no command turns
off auto-negotiation.
Sets the Ethernet port's connection speed in Mbps.
The no command returns the default setting.
Displays the Ethernet port negotiation, duplex, and
speed settings.
Displays statistics for the Ethernet ports.
Port1 Port2 Port3 Port4 Port5
yes no no no
no yes no no
no no yes no
no no no yes
no no no no
Port1 Port2 Port3 Port4 Port5
yes no no no
no yes no no
no no yes no
no no no yes
no no no no
Chapter 6 Interfaces
no
no
no
no
yes
yes
no
no
no
no
65