ZyXEL Communications ZYWALL - CLI Reference Manual page 240

Chapter 25 User/Group
Table 133 username/groupname Commands Summary: Settings (continued)
COMMAND
users default-setting [no] user-type <admin
|ext-user|guest|limited-admin|user>
show users retry-settings
[no] users retry-limit
[no] users retry-count <1..99>
[no] users lockout-period <1..65535>
show users simultaneous-logon-settings
[no] users simultaneous-logon {administration
| access} enforce
[no] users simultaneous-logon {administration
| access} limit <1..1024>
show users update-lease-settings
[no] users update-lease automation
show users idle-detection-settings
[no] users idle-detection
[no] users idle-detection timeout <1..60>
25.2.3.1 User Setting Command Examples
The following commands show the current settings for the number of simultaneous logins.
Router# configure terminal
Router(config)# show users simultaneous-logon-settings
enable simultaneous logon limitation for administration account: yes
maximum simultaneous logon per administration account
enable simultaneous logon limitation for access account
maximum simultaneous logon per access account
240
DESCRIPTION
Sets the default user type for each new user. The
no command sets the default user type to user.
Displays the current retry limit settings for users.
Enables the retry limit for users. The
disables the retry limit.
Sets the number of failed login attempts a user can
have before the account or IP address is locked out
for lockout-period minutes. The
the retry-count to five.
Sets the amount of time, in minutes, a user or IP
address is locked out after retry-count number of
failed login attempts. The
no
lockout period to thirty minutes.
Displays the current settings for simultaneous
logins by users.
Enables the limit on the number of simultaneous
logins by users of the specified account-type. The
command disables the limit, or allows an
no
unlimited number of simultaneous logins.
Sets the limit for the number of simultaneous logins
by users of the specified account-type. The
command sets the limit to one.
Displays whether or not access users can
automatically renew their lease time.
Lets users automatically renew their lease time.
The command prevents them from
no
automatically renewing it.
Displays whether or not users are automatically
logged out, and, if so, how many minutes of idle
time must pass before they are logged out.
Enables logging users out after a specified number
of minutes of idle time. The
logging them out.
Sets the number of minutes of idle time before
users are automatically logged out. The
command sets the idle-detection timeout to three
minutes.
ZyWALL (ZLD) CLI Reference Guide
command
no
command sets
no
command sets the
no
no command disables
no
: 1
: yes
: 3