ZyXEL Communications ZYWALL - CLI Reference Manual page 61

Table 20 interface Commands: OSPF Settings (continued)
COMMAND
ip ospf message-digest-key <1..255> md5
password
no ip ospf message-digest-key
[no] ip ospf hello-interval <1..65535>
[no] ip ospf dead-interval <1..65535>
[no] ip ospf retransmit-interval
<1..65535>
ZyWALL (ZLD) CLI Reference Guide
DESCRIPTION
Sets the ID and password for OSPF MD5
authentication in the specified interface.
password: 1-16 alphanumeric characters or
underscores
Clears the ID and password for OSPF MD5
authentication in the specified interface.
Sets the number of seconds between "hello"
messages to peer routers. These messages let
peer routers know the ZyWALL is available. The
command sets the number of seconds to 10.
no
See ip ospf dead-interval
information.
Sets the number of seconds the ZyWALL waits for
"hello" messages from peer routers before it
assumes the peer router is not available and
deletes associated routing information. The
command sets the number of seconds to 40. See
ip ospf hello-interval
information.
Sets the number of seconds the ZyWALL waits for
an acknowledgment in response to a link state
advertisement before it re-sends the
advertisement.
Link state advertisements (LSA) are used to share
the link state and routing information between
routers.
Chapter 6 Interfaces
for more
no
for more
61