ZyXEL Communications ZYWALL - CLI Reference Manual page 233

Table 126 device-ha Commands: VRRP Groups (continued)
COMMAND
[no] authentication {string password | ah-
md5 password}
[no] description description
[no] activate
24.6.2 VRRP Synchronization Commands
This table lists the commands for synchronization. You can synchronize with other ZyWALL's
of the same model that are running the same firmware version.
Table 127 device-ha Commands: Synchronization
COMMAND
show device-ha sync
show device-ha sync backup next-sync-time
show device-ha sync status
[no] device-ha sync from {hostname | ip}
[no] device-ha sync port <1..65535>
[no] device-ha sync authentication password
password
[no] device-ha sync auto
ZyWALL (ZLD) CLI Reference Guide
Chapter 24 Device HA
DESCRIPTION
Specifies the authentication method and password
for the specified VRRP group. The
means that the specified VRRP group does not use
authentication.
password: You may use alphanumeric characters,
the underscore, and some punctuation marks (+-/
*= :; .! @$&%#~ ' \ () ), and it can be up to eight
characters long.
Specifies the description for the specified VRRP
group. The command clears the description.
no
description: You can use alphanumeric and
()+/:=?!*#@$_%- characters, and it can be up
to 60 characters long.
Turns on the specified VRRP group. The
command turns off the VRRP group.
DESCRIPTION
Displays the current settings for synchronization.
Displays the next time and date (in hh:mm yyyy-
mm-dd format) the ZyWALL will synchronize with
the master.
Displays the current status of synchronization.
Specifies the fully-qualified domain name (FQDN)
or IP address of the ZyWALL router. Usually, this is
the IP address or FQDN of the virtual router. The
command clears this field.
no
hostname: You may up to 254 alphanumeric
characters, dashes (-), or periods (.), but the first
character cannot be a period.
Specifies the port number to use to synchronize
with the specified ZyWALL router. The
command resets the port to 21.
Specifies the password to use when synchronizing.
Every router in the virtual router should use the
same password. The command resets the
no
password to "1234".
password: You can use 4-63 alphanumeric
characters, underscores (_), dashes (-), and
#%^*={}:,.~ characters.
Specifies whether or not to automatically
synchronize at regular intervals.
no command
no
no
233