ZyXEL Communications ZYWALL - CLI Reference Manual page 325

Figure 36 atuk Command for Restoring the Recovery Image
4 Enter Y and wait for the "Starting XMODEM upload" message before activating
XMODEM upload on your terminal.
Figure 37 Starting Xmodem Upload
5 This is an example Xmodem configuration upload using HyperTerminal. Click
Transfer, then Send File to display the following screen.
Figure 38 Example Xmodem Upload
6 Wait for about three and a half minutes for the Xmodem upload to finish.
Figure 39 Recovery Image Upload Complete
7 Enter atgo. The ZyWALL starts up. If "Connect a computer to port 1 and FTP to
192.168.1.1 to upload the new file" displays on the screen, the firmware file is damaged
and you need to use the procedure in
ZyWALL (ZLD) CLI Reference Guide
Type the firmware file's
location, or click Browse to
search for it.
Choose the 1K Xmodem
protocol.
Then click Send.
Section 37.10 on page 326
Chapter 37 File Manager
to recover the firmware.
325