superbrightleds MWP4 Series User Manual

Important: Read all instructions prior to installation.
LED Mini Wall Pack
Safety and Notes
• Product should be installed and serviced by in accordance with applicable national,
state, and local building and electrical codes by qualified electricians or lighting
technicians.
• To reduce the risk of electric shock, ensure that the main power source and
circuit breakers are switched off before performing any installation or wiring procedures.
• Avoid looking directly into lamp when illuminated.
• Ensure all mounts are securely attached and will support the weight of the
fixture. Failure to properly support fixture may result in damage or injury, for
which the manufacturer does not assume responsibility.
• Before conducting installation, maintenance, or removal disconnect power and allow
fixture to cool down.
Photocell Bypass (optional)
1. Loosen screws and remove back
cover plate.
Specifications
Model
Ambient Operating Temperature
Environmental Rating
Input Voltage
Color Temperature
Power Consumption
Photocell Sensor
Check product label for specific electrical
specifications related to installation.
Improper installation will void warranty.
2. Loose screws and carefully remove
circuit board from inner housing.
Rev Date: V2.1 03/26/2024
4400 Earth City Expy, St. Louis, MO 63045
User Manual
MWP4 Series
MWP4-50K30
-22°–122° F (-30°–50° C)
IP65, suitable for wet locations
120 VAC
5000K
30 W
yes, bypassable
Wiring Diagram
120 VAC Input
Line
L
Neutral
N
Ground
GND
Dim (+)
+
Dim (-)
-
3. Unnplug wire connector from
photocell.
4. Place circuit board into position and
secure with screws.
866-590-3533
Black
L
White
N
Green
GND
Purple
+
Gray/Pink
-
superbrightleds.com