superbrightleds RSL Series User Manual

Important: Read all instructions prior to installation.
Recessed LED Step Lights

Included Parts

1 - step light (stainless steel or black finish)
1 - wire pigtail

Safety and Notes

• This product should be installed and serviced in accordance with
applicable national, state, and local building and electrical codes.
• To reduce the risk of electric shock, ensure that the main power source
and circuit breakers are switched off before performing any installation
or wiring procedures.
• While the light is IP68 water-resistant, the connectors built into the
harness are not.
• When interconnected, each six light accessory harness will support
five lights each instead of six.

Optional Accessories

RSL-6S - six light wire harness for single color light
RSL-S2M - 6.6 ft (2 m) extension harness for single color light
RSL-6RGB - six light wire harness for RGB lights
RSL-RGB3M - 9.8 ft (3 m) extension harness for single RGB light
Dimensional Drawings
RSL-40K1-S (Dimensions represent all models)
Rev Date: V1 09/26/2018
4400 Earth City Expy, St. Louis, MO 63045

Specifications

Model
Total Power Consumption
Operating Voltage Range
Operating Temperature
Beam Angle
Control/Dimming
Warranty

Installation

1. Mark and drill 5/8" hole in mounting surface.
2. Make electrical connection
3. Test fit light. If needed, apply silicone adhesive
to assist in securing light.
User Manual
Part Number:
RSL-Series
RSL-xK1-x RSL-RGB1-x
1 Watts
12 VDC
-4–122° F (-20–50° C)
150°
PWM 12 VDC RGB controller
3 Years
866-590-3533 superbrightleds.com