superbrightleds STAC Series User Manual

Important: SAVE THESE INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
120 VAC LED Strips

IMPORTANT SAFETY NOTES

• Do not cover this product as the covering may cause the flexible light to overheat, melt, and/or ignite.
• Do not operate with the strip tightly coiled.
• Do not puncture, cut, shorten, or splice the flexible lighting other than by the means instructed in this
manual and using approved accessories. Any modification that is required should only be done with
the power turned off/disconnected and by a certified electrician.
• Do not route the cord or strip through walls, doors, windows, or any like part of a building or structure.
• Do not use if there is any damage to the light or cord insulation. Inspect periodically.
• Do not submerge in liquids or use the product in the vicinity of standing water or other liquids.
• Secure this flexible light using only the optional clips or adhesive foam shown on the site. Do no secure
this product or its cord with staples, nails, or like means that may damage the insulation or permanently
attach to the building structure.
• Do not subject flexible lighting to continuous flexing.
• This product has a polarized 1-15P plug as a feature to reduce the risk of electric shock. This plug will
fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. Do not
use with an extension cord unless it is polarity specific and the plug can be fully inserted. Do not alter
or replace the plug.
WARNING: When using outdoor, basic safety precautions should always be followed to reduce
the risk of fire, electric shock, and personal injury. Ground fault circuit interrupter (GFCI) protection
must be used on the circuits or outlet when the strips are intended to be used outdoors. Receptacles
with built-in GFCI protection are the easiest way to facilitate this kind of connection.

Fuse Replacement

The 1-15P power cord (also sold as STAC-1-15P-50) has a built in fuse. There is also a spare stored
in the fuse compartment. If replacement is necessary beyond that, use similar 8 A 125 V fuse only.
Do not attempt to access or replace fuse unless cord is unplugged.
1. Grasp plug and remove from receptacle or other outlet device. Do not unplug by pulling on cord.
2. Slide open fuse cover on plug.
3. Remove fuse carefully and replace with spare located in plug or other compatible fuse.
WARNING: Risk of fire. Replace fuse with 8 amp, 125 volt fuse only.
4. Slide the fuse cover closed.
WARNING: Risk of fire. Do not replace attachment plug. It contains a safety device (fuse) that should
not be removed. Do not use product if the attachment plug is damaged in any way.

Mounting

Secure this flexible light using only the optional clips (STAC-CLIP) or adhesive foam shown on the site.
1. Mount clips at even increments where the strip is to be mounted.
2. With power switched off or disconnected, align strip with clips and snap fold-over clamp part
of the clip into place to secure the strip.
Rev Date: V1 04/26/2022
4400 Earth City Expy, St. Louis, MO 63045
User Manual
STAC Series
866-590-3533 superbrightleds.com