Figure 80 Advanced Application > Multicast > Multicast Setting > Mvr > Group Configuration; Table 47 Advanced Application > Multicast > Multicast Setting > Mvr >Group Configuration - ZyXEL Communications ES-2108 User Manual

Configure MVR IP multicast group address(es) in the Group Configuration screen. Click
Group Configuration in the MVR screen.
A port can belong to more than one multicast VLAN. However, IP multicast
group addresses in different multicast VLANs cannot overlap.
Figure 80 Advanced Application > Multicast > Multicast Setting > MVR > Group
Configuration
The following table describes the labels in this screen.
Table 47 Advanced Application > Multicast > Multicast Setting > MVR >Group Configuration
LABEL
Multicast
VLAN ID
Name
Start Address
End Address
Add
Cancel
MVLAN
Name
Start Address
End Address
ES-2108 Series User's Guide
DESCRIPTION
Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-
down list box.
Enter a descriptive name for identification purposes.
Enter the starting IP multicast address of the multicast group in dotted decimal
notation.
Refer to Section 19.1.1 on page 137
Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the Start Address field if you want to configure only one
IP address for a multicast group.
Refer to Section 19.1.1 on page 137
Click Add to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to reset the fields.
This field displays the multicast VLAN ID.
This field displays the descriptive name for this setting.
This field displays the starting IP address of the multicast group.
This field displays the ending IP address of the multicast group.
Chapter 19 Multicast
for more information on IP multicast addresses.
for more information on IP multicast addresses.
147