Mvr Group Configuration - ZyXEL Communications ES-2108 User Manual

Chapter 19 Multicast
Table 46 Advanced Application > Multicast > Multicast Setting > MVR (continued)
LABEL
Multicast VLAN
ID
802.1p Priority
Mode
Port
*
Source Port
Receiver Port
None
Tagging
Add
Cancel
VLAN
Active
Name
Mode
Source Port
Receiver Port
802.1p
Delete
Cancel

19.8 MVR Group Configuration

All source ports and receiver ports belonging to a multicast group can receive multicast data
sent to this multicast group.
146
DESCRIPTION
Enter the VLAN ID (1 to 4094) of the multicast VLAN.
Select a priority level (0-7) with which the Switch replaces the priority in outgoing
IGMP control packets (belonging to this multicast VLAN).
Specify the MVR mode on the Switch. Choices are Dynamic and Compatible.
Select Dynamic to send IGMP reports to all MVR source ports in the multicast
VLAN.
Select Compatible to set the Switch not to send IGMP reports.
This field displays the port number on the Switch.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select this option to set this port as the MVR source port that sends and receives
multicast traffic. All source ports must belong to a single multicast VLAN.
Select this option to set this port as a receiver port that only receives multicast
traffic.
Select this option to set the port not to participate in MVR. No MVR multicast traffic
is sent or received on this port.
Select this check box if you want the port to tag the VLAN ID in all outgoing frames
transmitted.
Click Add to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to reset the fields.
This field displays the multicast VLAN ID.
This field displays whether the multicast group is enabled or not.
This field displays the descriptive name for this setting.
This field displays the MVR mode.
This field displays the source port number(s).
This field displays the receiver port number(s).
This field displays the IEEE 802.1p priority level assigned to this VLAN.
To delete a multicast VLAN(s), select the rule(s) that you want to remove in the
Delete column, then click the Delete button.
Click Cancel to clear the Delete check boxes.
ES-2108 Series User's Guide