ZyXEL Communications ES-2108 User Manual page 83

Table 13 Basic Setting > Port Setup (continued)
LABEL
Speed/Duplex
Flow Control
802.1P Priority This priority value is added to incoming frames without a (802.1p) priority queue tag.
PD
(PWR model
Only)
Apply
Cancel
ES-2108 Series User's Guide
DESCRIPTION
Select the speed and the duplex mode of the Ethernet connection on this port.
For Ethernet ports, select Auto, 10M/Half Duplex, 10M/Full Duplex, 100M/Half
Duplex or 100M/Full Duplex.
For the Gigabit Ethernet/mini-GBIC slot, select Auto, 10M/Half Duplex, 10M/Full
Duplex, 100M/Half Duplex, 100M/Full Duplex or 1000M/Full Duplex.
For the mini-GBIC slot on the ES-2108-LC, select Auto or 1000M/Full Duplex.
The port speed and the duplex mode are fixed (100M/Full Duplex) for the 100 Base-
FX fiber optic port on the ES-2108-LC and the Fast Ethernet SFP transceiver
connection on the ES-2108-F.
Selecting Auto (auto-negotiation) allows one port to negotiate with a peer port
automatically to obtain the connection speed and duplex mode that both ends
support. When auto-negotiation is turned on, a port on the Switch negotiates with the
peer automatically to determine the connection speed and duplex mode. If the peer
port does not support auto-negotiation or turns off this feature, the Switch determines
the connection speed by detecting the signal on the cable and using half duplex
mode. When the Switch's auto-negotiation is turned off, a port uses the pre-
configured speed and duplex mode when making a connection, thus requiring you to
make sure that the settings of the peer port are the same in order to connect.
A concentration of traffic on a port decreases port bandwidth and overflows buffer
memory causing packet discards and frame losses. Flow Control is used to regulate
transmission of signals to match the bandwidth of the receiving port.
The Switch uses IEEE802.3x flow control in full duplex mode and back-pressure flow
control in half duplex mode.
IEEE802.3x flow control is used in full duplex mode to send a pause signal to the
sending port, causing it to temporarily stop sending signals when the receiving port
memory buffers fill.
Back Pressure flow control is typically used in half duplex mode to send a "collision"
signal to the sending port (mimicking a state of packet collision) causing the sending
port to temporarily stop sending signals and resend later. Select Flow Control to
enable it.
See Priority Queue Assignment in
This field is only available on the PWR model but not available for the Gigabit or mini-
GBIC slots.
A powered device (PD) is a device such as an access point or a switch, that supports
PoE (Power over Ethernet) so that it can receive power from another device through a
10/100Mbps Ethernet port.
Select the check box to allow a powered device (connected to the port) to receive
power from the Switch.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to reset the fields to your previous configuration.
Chapter 7 Basic Setting
Table 11 on page 77 for more information.
83