Configuring Dhcp Global Relay; Figure 110 Ip Application > Dhcp > Global; Table 71 Ip Application > Dhcp > Global - ZyXEL Communications ES-2108 User Manual

Table 70 Relay Agent Information
FIELD LABELS
VLAN ID
Information

25.3.2 Configuring DHCP Global Relay

Configure global DHCP relay in the DHCP Relay screen. Click IP Application > DHCP in
the navigation panel and click the Global link to display the screen as shown.
Figure 110 IP Application > DHCP > Global
The following table describes the labels in this screen.
Table 71 IP Application > DHCP > Global
LABEL
Active
Remote
DHCP Server
1 .. 3
Relay Agent
Information
Information
Apply
Cancel
ES-2108 Series User's Guide
DESCRIPTION
(2 bytes) This is the VLAN that the port belongs to.
(up to 64 bytes) This optional, read-only field is set according
to system name set in Basic Settings > General Setup.
DESCRIPTION
Select this check box to enable DHCP relay.
Enter the IP address of a DHCP server in dotted decimal notation.
Select the Option 82 check box to have the Switch add information (slot number, port
number and VLAN ID) to client DHCP requests that it relays to a DHCP server.
This read-only field displays the system name you configure in the General Setup
screen.
Select the check box for the Switch to add the system name to the client DHCP
requests that it relays to a DHCP server.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 25 DHCP
191