Link Aggregation Control Protocol; Figure 64 Advanced Application > Link Aggregation > Link Aggregation Setting > Lacp; Table 36 Advanced Application > Link Aggregation > Link Aggregation Setting > Lacp - ZyXEL Communications ES-2108 User Manual

Chapter 15 Link Aggregation

15.5 Link Aggregation Control Protocol

Click in the Advanced Application > Link Aggregation > Link Aggregation Setting >
LACP to display the screen shown next. See
on dynamic link aggregation.
Figure 64 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
The following table describes the labels in this screen.
Table 36 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL
Link
Aggregation
Control
Protocol
Active
System
Priority
Group ID
LACP Active
Port
124
DESCRIPTION
Note: Do not configure this screen unless you want to enable
dynamic link aggregation.
Select this checkbox to enable Link Aggregation Control Protocol (LACP).
LACP system priority is a number between 1 and 65,535. The switch with the lowest
system priority (and lowest port number if system priority is the same) becomes the
LACP "server". The LACP "server" controls the operation of LACP setup. Enter a
number to set the priority of an active port using Link Aggregate Control Protocol
(LACP). The smaller the number, the higher the priority level.
The field identifies the link aggregation group, that is, one logical link containing
multiple ports.
Select this option to enable LACP for a trunk.
This field displays the port number.
Section 15.2 on page 121
ES-2108 Series User's Guide
for more information