Mvr Group Configuration - ZyXEL Communications VES1724-56 User Manual

Table 94 Advanced Application > Multicast > Multicast Setting > MVR (continued)
LABEL
802.1p
Delete
Cancel

24.8 MVR Group Configuration

All source ports and receiver ports belonging to a multicast group can receive multicast data sent to
this multicast group.
Configure MVR IP multicast group address(es) in the Group Configuration screen. Click Group
Configuration in the MVR screen.
Note: A port can belong to more than one multicast VLAN. However, IP multicast group
addresses in different multicast VLANs cannot overlap.
Figure 132 Advanced Application > Multicast > Multicast Setting > MVR: Group Configuration
The following table describes the labels in this screen.
Table 95 Advanced Application > Multicast > Multicast Setting > MVR: Group Configuration
LABEL
Multicast VLAN
ID
Name
Start Address
VES1724-56 User's Guide
DESCRIPTION
This field displays the priority level.
To delete a multicast VLAN(s), select the rule(s) that you want to remove in the Delete
column, then click the Delete button.
Click Cancel to clear the Delete check boxes.
DESCRIPTION
Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-down list
box.
Enter a descriptive name for identification purposes.
Enter the starting IPv4 or IPv6 multicast address of the multicast group in dotted decimal
notation.
Refer to Section 24.1.1 on page 217 for more information on IP multicast addresses.
Chapter 24 Multicast
229