Main Window; Right-Click Menus - ZyXEL Communications ENTERPRISE NETWORK CENTER Manual

The following table describes the labels in the Add Link screen.
Table 9 Map > Background
LABEL
Link Label
(Name)
Link Endpoint 1
Link Endpoint 2
Interface Index
Associated IP
Link Type
Description
Cancel
Ok
After you configure the link settings completely, a line displays between two nodes. The link
becomes gray when the ENC is trying to send poll messages to the device. It is green when the
connection between two nodes is up or red when they are disconnected.

1.3.4 Main Window

The main window shows the screen you select in the navigation panel (D in
The main window screens are discussed in the rest of this document.
Right after you log in, the Dashboard screen is displayed. See
information about the Dashboard screen.

1.3.5 Right-click Menus

In the OTV panel, right-click the Root Subnet network, a network under Root Subnet or a device,
different menus display respectively. These menus provide a shortcut to execute a function for the
network or device.
ENC User's Guide
DESCRIPTION
Enter up to 32 characters for the link's name for identification purposes. You can
use alphanumeric characters (0-9, a-z, A-Z), arrow brackets (<>), underscores
(_), hyphen (-), dot (.) and spaces.
This field displays the first node's IP address that you selected.
This field displays the second node's IP address that you selected.
Enter the index number of a port or an interface on the device you specified in the
Associated IP field. The ENC will monitor it to check the connectivity. Refer to
the device's User's Guide for the number of the port or interface you should enter.
Enter the IP address of the endpoint 1 or 2 device. The ENC will use it to check
and determine whether this link is up or down.
Select the type and the maximum transmission speed of this link. If you are not
clear about the settings, leave them to the defaults.
Type additional information for this link in this field.
Click this to discard the changes and exit this screen.
Click this to save the changes and exit this screen.
Chapter 1 Web Configurator
Figure 6 on page
Chapter 3 on page 85 for more
24).
33