Setting Bit-Dept On T-Class Cards - Tech Source RAPTOR 1100T - DRIVERS FOR LINUX INSTALLATION-REFERENCE Installation And Reference Manual

5.6.2 Setting Bit-Depth on T-Class Cards
The T-Class cards support the 8-bit, 24-bit, 8+24-bit, 8+8,
mox16, mox24 and mox32 modes.
versions of T-Class cards additionally support mox16radar,
mox24radar and 8radar. By default these cards start up in 8-bit
mode.
These modes can be selected by modifying the Device section
and Screen section of the XF86Config file appropriately.
To set bit-depth to 8-bit, the "Mode" option in the Device
section needs to be set to 8 and the other values should remain
unchanged.
To set bit-depth to 24, the "Mode" option needs to be set to
"24" as shown:
Section "Device"
Identifier
Driver
Card
BusID
Option
Option
Option
EndSection
To select 8+24-bit mode, the "Mode" option should be set to
8+24 as shown in the following example. In this case the default
visual is 8-bit PsuedoColor.
Section "Device"
Identifier
Driver
Card
BusID
Option
Option
Option
EndSection
Chapter 5 – Invoking The X Server
Radar Scan capable
"Raptor1.1KT"
"rapt"
"TSI Raptor 1100T"
"PCI:0:12:0"
"Device" "/dev/rap1kt0"
"Mode" "24"
"ScaleCursPos" "on"
"Raptor1.1KT"
"rapt"
"TSI Raptor 1100T"
"PCI:0:12:0"
"Device" "/dev/rap1kt0"
"Mode" "8+24"
"ScaleCursPos" "on"
5-7