Serverlayout Section - Tech Source RAPTOR 1100T - DRIVERS FOR LINUX INSTALLATION-REFERENCE Installation And Reference Manual

Raptor Drivers for Linux Installation and Reference Manual
If multiple Raptor cards are installed, additional Screen
sections should be created.
unchanged. For more information please refer to Section 5.5.

4.6.4 ServerLayout Section

This is the section which specifies the server layout for either
single-screen or multi-screen configuration.
NOTE: The ServerLayout section should already exist in
your XF86Config file. It must be modified manually to
include the Raptor card.
This section is not modified automatically by the installation. It
must be modified for your specific configuration.
The following example shows the ServerLayout Section for a
single-screen configuration on the Raptor device.
Section "ServerLayout"
Identifier "XFree86 Configured"
Screen 0
InputDevice
InputDevice
EndSection
Assuming Screen0 is the console card, the following example
shows the ServerLayout section with the Raptor card as the
second screen.
Section "ServerLayout"
Identifier "XFree86 Configured"
Screen 0
Screen 1
InputDevice
InputDevice
EndSection
Other fields should remain
"Raptor2100T" 0 0
"Mouse0" "CorePointer"
"Keyboard0" "CoreKeyboard"
"Screen0" LeftOf "Raptor2100T"
"Raptor2100T" RightOf "Screen0"
"Mouse0" "CorePointer"
"Keyboard0" "CoreKeyboard"
4-10