Serverlayout Section - Tech Source RAPTOR 1100T - DRIVERS FOR LINUX INSTALLATION-REFERENCE Installation And Reference Manual

Raptor Drivers for Linux Installation and Reference Manual

3.6.4 ServerLayout Section

This is the section which specifies the server layout for either
single-screen or multi-screen configuration.
NOTE: The ServerLayout section should already exist in
your XF86Config file. It must be modified manually to
include the Raptor card.
This section is not modified automatically by the installation. It
must be modified for your specific configuration.
The following example shows the ServerLayout Section for a
single-screen configuration on the Raptor device.
Section "ServerLayout"
Identifier "XFree86 Configured"
Screen 0
InputDevice
InputDevice
EndSection
Assuming Screen0 is the console card, the following example
shows the ServerLayout section with the Raptor card as the
second screen.
Section "ServerLayout"
Identifier "XFree86 Configured"
Screen 0
Screen 1
InputDevice
InputDevice
EndSection
NOTE: For the Raptor Drivers to work properly, NO other
cards using the XF86 i128 driver should be specified in
the ServerLayout section. This limitation is due to the
fact that the XF86 i128 driver will claim all i128 based
cards. Since the i128 driver will not initialize the Raptor
card correctly, the Tech Source driver must be used.
"Raptor2000" 0 0
"Mouse0" "CorePointer"
"Keyboard0" "CoreKeyboard"
"Screen0" LeftOf "Raptor2000"
"Raptor2000" RightOf "Screen0"
"Mouse0" "CorePointer"
"Keyboard0" "CoreKeyboard"
3-8