Monitor Section; Device Section - Tech Source RAPTOR 1100T - DRIVERS FOR LINUX INSTALLATION-REFERENCE Installation And Reference Manual

Raptor Drivers for Linux Installation and Reference Manual

3.6.1 Monitor Section

This section for Raptor cards should remain unchanged.

3.6.2 Device Section

Identifier: Each Raptor card instance should have a
unique identifier. This identifer is used in the
Screen section.
NOTE: The BusID value in the configuration file must be
changed manually. Please see the description below for details.
BusID: Depending on the machine and the slot the
card is in, it might receive a unique BusID.
When the driver attaches, it will print out the
device name and BusID.
BusID, type dmesg|grep
output should look similar to the following:
TSI:
Raptor 2500 @ 2560x2048
TSI:
Raptor 2000 @ 2048x2048.
In the example above, the Raptor 2000 has
a BusID of PCI:0:10:0, while the Raptor
2500 has a BusID of PCI:0:9:0. Change
the BusIDs of the cards in XF86Config to
match the BusIDs reported by the drivers.
To check the
rapqfp0 (BusID 0:9:0) is
raptor0 (BusID 0:10:0) is
3-6
The
rap.