Screen Section - Tech Source RAPTOR 1100T - DRIVERS FOR LINUX INSTALLATION-REFERENCE Installation And Reference Manual

Chapter 3 – Software Installation for I-Class Cards
Option "Device": This field specifies the device name of the
Raptor card. The first Raptor card seen by
the system will be /dev/raptor0 and the
second will be /dev/raptor1 and so on.
For Raptor 2500, the device name will be
rapqfp0 and so on. The device name and
the BusID specified earlier in this section
must correspond to the same card.
Option "MOX": MOX (Multiple Overlay Extension) is a fea-
ture available on Raptor cards that provides
multi-layer
modes are mox16 and mox24. The sample
Device section listed uses mox24 mode.
MOX is disabled by default. Therefore, this
line is commented out in the example given.
See Section 5.6 for more details on
configuring MOX.
If more than one Raptor 2000 or Raptor 2500 card is installed,
a separate Device section must be created for each card.
Each Device section should have a unique Identifier
BusID and Device option fields. Other fields should remain
unchanged. For more information please refer to Section 5.5.

3.6.3 Screen Section

Identifier: Each screen must have a unique identifier
which will be used in the ServerLayout
section.
Device: This field specifies which device you want to
use for this screen. It should match the
Identifier specified in one of the Device
sections.
If multiple Raptor cards are installed, additional Screen
sections should be created.
have a unique identifier. For more information please refer to
Section 5.5.
capability. Available
Each Screen section should
3-7
MOX