Installation Of The Raptor 2500 Fps - Tech Source RAPTOR 1100T - DRIVERS FOR LINUX INSTALLATION-REFERENCE Installation And Reference Manual

Raptor Drivers for Linux Installation and Reference Manual
Step 2: Install the Raptor graphics card firmly into the
PCI slot.
snugly into the slot. Once you are certain the
card is installed properly in the slot, secure it
with the bracket screw.
Step 3: Secure
previously removed cables, and connect the
video card to your monitor.
The Raptor graphics card is now installed and the system is
ready for software installation.
installing and configuring the "Raptor Drivers for Linux" software.
2.3

Installation of the Raptor 2500 FPS

The Raptor 2500 FPS Digital Flat Panel subsystem is comprised
of the Raptor 2500T graphics card (configured for 2560x2048
resolution), the Tech Source 2500 FPS digital flat panel, along
with associated cables and software.
graphics card is connected to the Tech Source 2500 FPS digital
flat panel using a cable as shown in Figure 2-1.
The Raptor 2500T card has one connector on the front bracket.
One side of the provided cable has the LFH60 connector that
connects to the graphics card. The cable splits into two with
MDR26 connectors on the opposite end. These two connectors
marked A & B get connected to the appropriately marked
connectors on the back of the digital flat panel. They are shown
in Figure 2-1.
Take care to press it evenly and
the system's cover,
Refer to Chapter 3 or 4 for
The Raptor 2500T
2-2
attach any