Tech Source RAPTOR 1100T - DRIVERS FOR LINUX INSTALLATION-REFERENCE Installation And Reference Manual page 31

Chapter 4 – Software Installation for T-Class Cards
Monitor: This field should remain unchanged for the
Raptor 2100T, Raptor 3840T and the Raptor
2500T.
should contain the identifier of the Monitor
section that will be used with this card.
Refer to the XFree86 documentation for
instructions on how to create a custom
Monitor section.
DefaultDepth: Should be set to either 8 or 24 depending
on the default visual desired. This is used
when 24-bit visuals will be used on the
screen, otherwise this field should be set to
8.
Modes: This field should remain unchanged for the
Raptor 2100T, Raptor 3840T and the Raptor
2500T. It may be modified to change the
resolution of a Raptor 1100T card.
The following sample screen section shows the 1100T
configured for 1280x1024.
Section "Screen"
Identifier "Raptor1100T"
Device
Monitor
DefaultDepth
SubSection "Display"
Depth
Modes
EndSubSection
SubSection "Display"
Depth
Modes
EndSubSection
SubSection "Display"
Depth
Modes
EndSubSection
EndSection
For the Raptor 1100T, this field
"Raptor1.1KT"
"CustomMonitor"
8
8
"1280x1024"
16
"1280x1024"
24
"1280x1024"
4-9