New Device; Changing Resolution - Tech Source RAPTOR 1100T - DRIVERS FOR LINUX INSTALLATION-REFERENCE Installation And Reference Manual

Raptor Drivers for Linux Installation and Reference Manual
8. To install the MOX package, type:
prompt# cd /mnt/cdrom/linux/moxlib
prompt# rpm -Uvh tsimox-*.rpm
NOTE: You must install the MOX package if you plan on running
the cards in MOX mode. The MOX package is common to both
I-Class and T-Class cards.
4.4

New Device

One new device name is created in the /dev directory for each
Raptor card. It is denoted by rap2kt# for the Raptor 2100T,
raptfp# for the Raptor 2500T and rapifp# for Raptor 3840T
and rap1kt# for the Raptor 1100T where # represents an
instance number assigned by the operating system. For
example, /dev/rap2kt0 is the first Raptor 2100T card seen by
the system. /dev/rap2kt1 will be the second Raptor 2100T
card seen by the system and so on.
4.5

Changing Resolution

The resolutions for Raptor 2100T and Raptor 2500T are fixed.
They are shown in the table below. The resolution of the 1100T
and Raptor 3840T can be changed by changing the value of the
Modes field in the Screen section of XF86Config. See Section
5.7 for more information.
Graphics Card Resolution
Raptor 2100T 2048x2048
Raptor 2500T 2560x2048
2048x2048
Raptor 1100T Up to
1920x1200
Raptor 3840T Up to
3840x2400
Monitor Supported
Sony DDM 2800
TSI 2500 FPS
TSI 2100 FPS
Various
9.2 Mega Pixel
Color Display
4-4
Interface
Analog
Digital
Analog
Digital