Software Installation For T-Class Cards; Overview; Requirements - Tech Source RAPTOR 1100T - DRIVERS FOR LINUX INSTALLATION-REFERENCE Installation And Reference Manual

SOFTWARE INSTALLATION FOR
4.1

Overview

This installation chapter describes how to install and configure
the drivers for T-Class Raptor cards.
includes the following:
•
Raptor 2100T
•
Raptor 2500T
•
Raptor 1100T
•
Raptor 3840T
The installation of I-Class Raptor cards is covered in Chapter 3.
4.2

Requirements

The following are prerequisites for installing the Raptor Drivers
for Linux Software:
•
At least 2MB of disk space available in "/" and "/usr" for
drivers.
•
A Raptor card is presently installed in the workstation/server
(See Chapter 2 for instructions on installing a Raptor
graphics card).
•
Linux Kernel v2.2.x or v2.4.x installed
•
XFree86 (v4.0 or later) installed and configured for the
current console graphics card
•
RPM (v3.0 or later) packaging tools
The device driver and DDX module for Linux and XFree86 are
loadable. No kernel changes or X server rebuilds are required.
Chapter 4
T-CLASS CARDS
This class of cards
4-1