Optional Accessories - Simpleway nnounce micnode2 Hardware User's Manual

micnode2 – Hardware User Guide
•
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where
they exit from the apparatus.
•
Only use attachments/accessories specified by the manufacturer.
•
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate normally, or has been dropped.
•
Adhere to all applicable, local codes.
•
Consult a licensed, professional engineer when any doubt or questions arise regarding a physical equipment installation.
The product is not intended to be installed as a system for providing emergency voice communication or to be installed in areas
specified by ANSI/ NFPA 72, "National Fire Alarm Code."
The device has been tested for compliance:
• ICES-003:2020-10
• EN 55032:2015 / DIN EN 55032:2015/A11:2021 Electromagnetic compatibility
of multimedia equipment – Emission Requirements / (CISPR
32:2015/AMD1:2019)
•
ENT 55035:2017 / DIN EN 55035:2017/A11:2022 Electromagnetic
compatibility of multimedia equipment – Immunity requirements / (CISPR
35:2016)
FCC Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
RoHS Statement
Directive 2002/95/EC – Restriction of Hazardous Substances (RoHS)
Unpacking
1. micnode2 microphone station with an 8-inch touch panel (1920x1200)
2. Handheld microphone
3. Wall-mounting station holder
4. Six screws for attaching the microphone station to the holder
5. Two terminal blocks for audio and contact cables

Optional accessories

1. Desktop stand
2. micnode aux extension unit
TM
nnounce by Simpleway
3