Table of Contents
Advertisement
SilverV-EN.book Page 110 Monday, May 15, 2000 3:23 PM
Remarks
• If you use paste-up originals, select Paste Shadow Erase mode (see
"Paste Shadow Erase—Erasing the Shadow of Pasted Originals") make sure that
the pasted parts hold firmly to the base sheet. If the thickness of the paste-up
originals is more than 0.1mm and the space between the pasted parts is less
than 2mm, 0.08", a shadow might appear on the print.
• Under the following conditions, the machine might not detect the original on
the exposure glass. If you press the {Start} key again, the machine will start
making a master anyway:
• When you set a dark original on the exposure glass.
• When the original is not centered according to the size marks on the right
scale.
• If you do not open the platen cover at an angle of more than 25 degrees
with the exposure glass when you replace originals.
• If the machine is installed under a strong light.
6
110
P.22
Advertisement
Chapters
Table of Contents
