Ricoh AP2600N User Manual page 410

UNIX Configuration
E
Enter the IP address of the printer.
Enter Printer host IP address <xxx.xxx.xxx.xxx> [re-
turn=skip]:
192.168.15.16
1
Note
❒ The IP address will be added to the /etc/hosts file.
❒ If the host name of the printer has already been configured, ignore and
press the {RETURN} key. Nothing is added to the /etc/hosts file.
F
Enter the host name of the printer.
Enter Printer host name : nphost
Note
❒ The host name will be added to the /etc/hosts file.
❒ If no IP address was entered in step E, nothing is added to the /etc/hosts file.
G
Configure the printer name.
Enter logical printer name [default nphost_prn]
If you want to use the default name, press the {RETURN} key. If you want to
change this name, enter a new name.
Note
❒ The host name entered in step F followed by "_prn" appears in "default".
H
Set the print option.
Enter remote printer name [default lp]:
• Press the {RETURN} key, print with PCL or PostScript is enabled.
• If you want to set the device option, enter the option parameter.
Enter remote printer name [default lp]:duplex=on
For more information about device option, see P.15 "Specifying the Device Option".
• If you enter "text", text printing is enabled.
If you enter "text", printing with PCL and PostScript is unavailable.
Enter remote printer name [default lp]:filetype=text
Limitation
❒ You can enter up to 11 characters for HP-UX 11.0, 256 for Solaris 8, and 51
for Red Hat Linux 6.2.
❒ Solaris 2.6 or more cannot accept (,). And you must use (_) instead of (=).
So you can set the only one print option.
Setup with the installation shell script is finished. If you enter the IP address
in step E, the following message appear.
hosts file is modified
4