Ricoh AP2600N User Manual page 156

Troubleshooting
Messages/Second messages
Hardware Problem
Option RAM
5
Hardware Problem
Shift Tray
HDD Full
HDD Not Installed
Hex Dump Mode
62
Description
An error has occurred in the
optional Memory Unit.
An error has occurred in the
shift motor of the shift tray.
The optional Hard Disk Drive
is full. The sample print job or
locked print job to be sent
from the computer is too large
to store.
You cannot print the sample
print and the locked print
jobs, because the optional
Hard Disk Drive is not in-
stalled.
The printer is in Hex Dump
Mode.
Solution
First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
Turn off the power switch, Re-
place the Memory Unit, and
then turn on the power
switch. See "Installing Memory
Unit TypeB 64MB" in the Setup
Guide.
Turn off the power switch, re-
move the Memory Unit, and
then turn on the power
switch.
Note
❒ If you remove the Memory
Unit, you must set up the
option with the printer
driver. If you are using
Windows 95/98/Me, Win-
dows 2000 and Windows
NT 4.0, see "Installing the
Printer Driver and Software"
in the Setup Guide.
❒ In this case, you might not
be able to print complex
print jobs.
First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
Delete any unnecessary stored
files.
Install the Hard Disk Drive.
See "Installing Hard Disk Drive
Type 2600" in the Setup Guide.
Wait for a while. If the "Hex
Dump Mode" message does
not change, on the panel dis-
play press {Online} to return
to the "Ready" condition.