Ricoh AP2600N User Manual page 343

Network Boot
Use the set command to configure the boot method.
msh> set parameter {on | off}
"on" means active and "off" means inactive.
Parameter
dhcp
Note
❒ When you use DHCP, the server also needs to be configured.
❒ DHCP takes precedence over all other settings.
Protocol
Use the set command to allow/prevent remote access for each protocol.
msh> set protocol {up | down}
Protocol
appletalk
tcpip
netware
netbeui
lpr
ftp
rsh
diprint
web
snmp
ipp
Note
❒ If you prohibit remote access using TCP/IP and then log out, you cannot use
remote access. If this was a mistake, you can use the printer operation panel
to allow access by TCP/IP.
❒ When you prevent access via TCP/IP, you are also prevented from using lpr,
ftp, rsh, diprint, web, snmp and ipp.
Meaning
DHCP (Dynamic Host Configuration
Protocol)
"up" means active and "down" means
inactive.
Remote Maintenance by telnet
6
79