Ricoh AP2600N User Manual page 349

SLP
Use this command to configure SLP settings.
You can search the NetWare server using SLP in the PureIP environment of
NetWare5. To use the slp command, you can configure the value of TTL which
can be used by SLP multi-cast-packet.
Note
❒ The default value of TTL is "1". A search is executed only within a local seg-
ment. If the router does not support multi-cast, the settings are not available
even if the TTL value is increased.
❒ The acceptable TTL value is 1 - 255.
msh> slp ttl ttl_{1 -255}
Changing the password
Use the passwd command to change the remote maintenance password.
Important
❒ Be sure not to forget or lose the password.
Note
❒ The default factory password is "password".
A
Type "passwd".
msh> passwd
B
Type the current password.
Old password:
C
Type the new password.
New password:
Note
❒ The password must consist of 3 to 8 alphanumeric characters and symbols.
Upper and lower case characters are considered unique. For example, R is
different from r.
❒ The password is the same as that used in the configuration of the Network
Interface Board using a Web Browser and that used in the NIB Setup Tool.
If you change a password from telnet, the other passwords are also
changed.
D
Type the new password once again.
Retype new password:
Remote Maintenance by telnet
6
85