Ricoh AP2600N User Manual page 345

SNMP
Use the snmp command to display and edit SNMP configuration settings such
as the community name.
Note
❒ You can configure from ten SNMP access settings numbered 1–10.
❒ Default access settings 1 and 2 are as follows.
Number
Community name
IP address
Access type
❖ ❖ ❖ ❖ Display
Shows the SNMP information and available protocols.
msh> snmp ?
msh> snmp [-p] [registered_number]
Note
❒ If the -p option is added, you can view the settings one by one.
❒ Omitting the number displays all access settings.
❖ ❖ ❖ ❖ Community name configuration
You can set the community name of the Network Interface Board.
msh> snmp number name community_name
Note
❒ The community name must consist of 15 characters or less.
❖ ❖ ❖ ❖ Access type configuration
You can select the access type from those listed below.
msh> snmp number type access_type
Access type
read
write
trap
no
1
public
0.0.0.0
read-only
trap off
Type of access which is permitted
Read only
Read and write
User is notified of trap messages.
All access is denied.
Remote Maintenance by telnet
2
admin
0.0.0.0
read-write
trap off
6
81