Ricoh AP2600N User Manual page 159

Messages/Second messages
Remove Misfeed
Upper Tray Unit
/Open Upperr
Tray Cover
Remove Paper
All Output Trays
Remove Paper
From Upper Tray
Remove Paper
Mailbox Tray #
Remove Paper
Standard Tray
Replace
Maintenance Kit
Replace
Toner Cartridge
Reset Duplex
Unit Correctly
Reset Fusing
Unit Correctly
Reset Toner
Cartridge
Error & Status Messages on the Operation Panel
Description
There is a misfeed in the up-
per tray unit.
All output trays are full, and
the print job is suspended.
The upper tray is full, and the
print job is suspended.
The Mailbox is full, and the
print job is suspended.
The standard tray is full, and
the print job is suspended.
It is time to replace parts in-
cluded in the Maintenance
Kit.
The toner cartridge is not set
correctly or toner is almost
run out.
The toner dust is full.
The optional Duplex Unit is
not set correctly.
An error has occurred in the
Duplex Unit.
The fusing unit is not set cor-
rectly.
The toner cartridge is not set
correctly.
The toner cartridge is not set
installed.
Solution
Remove the misfed paper.
Remove paper from all output
trays, and the print job will be
resumed automatically.
Remove paper from the upper
tray, and the print job will be
resumed automatically.
Remove paper from the Mail-
box, and the print job will be
resumed automatically.
Remove paper from the stand-
ard tray, and the print job will
be resumed automatically.
Replace parts. See P.132
"MAINTENANCE KIT Type
2600".
Set the toner cartridge correct-
ly. See P.88 "Replacing the Ton-
er Cartridge".
Prepare a new toner cartridge.
If the image density gets too
light, replace the toner car-
tridge with a new one. See
P.88 "Replacing the Toner Car-
tridge".
Set the optional Duplex Unit
correctly. If the message ap-
pears again, call your sales or
service representative.
Set the fusing unit correctly,
or set the proper fusing unit.
Set the toner cartridge correct-
ly. See P.88 "Replacing the Ton-
er Cartridge".
If the cartridge is installed,
close the front cover and turn
the off power switch and then
on. If the message appears
again, contact your sales or
service representative.
5
65