Flow Effect Shooting - Panasonic AG-HPX250 Operating Instructions Manual

Flow effect shooting

This way of shooting provides a flow effect and
may, for instance, be used to shoot a subject on
a far side of a road with a stream of fast-moving
cars as the flow, in such a way that the stationary
subject comes into focus though the cars.
1
Set SYSTEM MODE on the setting menu
SYSTEM SETUP screen to 1080-59.94i (50i),
REC FORMAT to AVC-I 100 (50)/60i (50i) or
DVCPRO HD/60i (50i), and VFR to ON.
Set FRAME RATE to a low value suitable for
the shooting purpose.
Setting can be performed in the same way for
720P.
2
Press the START/STOP button.
This starts recording in the VFR mode.
During flow effect shooting - general
notes
• Please take note of the following points when
selecting AVC-Intra recording.
· When 1080i is selected, the image signal and
HD SDI output signal recorded are 60i (50i) and
all frames are effective frames.
· With both 1080i and 720P, pull down information
is not attached to recorded clips.
When you wish to use this information, select
DVCPRO HD mode with 720P.
• Audio recording will be recorded onto P2 card at
all frame rates.
• Fixed shutter and synchro scan are valid.
27