One-Shot Recording (One Shot Rec) - Panasonic AG-HPX250 Operating Instructions Manual

• The pre-recording and one-clip recording
functions are not available.
• Sound is not recorded.
• Data recorded (until the stop recording) in
this mode is recorded as a single file.
• There is no output from the DVCPRO/DV
connector.

One-shot recording (ONE SHOT REC)

This function records a single shot at each unit of
time which has been set.
1
Check that the SYSTEM SETUP screen is
set up as described on page 43.
• Refer to the section "Using the setup menus"
(Page 28 of Vol. 1) for menu operation.
2
Select ONE SHOT in the menu option REC
FUNCTION in the RECORDING SETUP
screen. (Page 141)
3
Set the time in the menu option ONE SHOT
TIME in the RECORDING SETUP screen.
(Page 141)
4
Press the START/STOP button.
• The camera-recorder will pause recording
after making a recording that lasts the
duration set in step 3.
• Push the Operation lever in the  direction
(STOP) to stop recording.
• To cancel this function, turn the camera-
recorder off or select NORMAL in the REC
FUNCTION option.
• The following indications appear to the left of
the operation status display.
· During recording: "I-REC" stays lit.
· During a pause: "I-PAUSE" stays lit.
· When stopped: "I"- in "I-PAUSE" blinks.
• No other functions are available during
operation.
• The pre-recording and one-clip recording
functions are not available.
• Sound is not recorded.
• Data recorded (until the stop recording) in
this mode is recorded as a single file.
• There is no output from the DVCPRO/DV
connector.
• During continuous one-shot recording,
recording operation speed may be
decreased.
45