Recording Method - Panasonic AG-HPX250 Operating Instructions Manual

Thumbnail operations (continued)
To set whether or not the uploaded
metadata is recorded
Set ON/OFF in META DATA → RECORD from the
thumbnail menu. The factory setting is OFF.
Selecting the USER CLIP NAME

recording method

Select META DATA → USER CLIP NAME from the
thumbnail menu to select the recording method.
Two options are available: TYPE1 and TYPE2.
• TYPE1 (Factory setting)
If clip metadata has
been read in
If no clip metadata has
been read in or if the
setting for recording
clip metadata has
been turned off
• TYPE2
If clip metadata has
been read in
If no clip metadata has
been read in or if the
setting for recording
clip metadata has
been turned off
90
USER CLIP NAME to be
recorded
Uploaded data
Same as GLOBAL CLIP
ID (UMID data)
USER CLIP NAME to be
recorded
Uploaded data + COUNT
value*
Same as CLIP NAME
* T he COUNT value is indicated as a four-digit
number.
The COUNT value is incremented each time a
new clip is captured if clip metadata has been
read in and TYPE2 has been selected as the
recording method.
The COUNT value can be reset using the
following procedure.
Select META DATA → PROPERTY from the
thumbnail menu, then select USER CLIP NAME
to display the menu shown below.
Select COUNT RESET with the Operation lever
and press the SET button on the Operation lever
to reset the COUNT value to 1.
When a P2 card with a memory capacity of 8
GB or more is used in camera-recorder and a
one-time continuous recording exceeds the
prescribed duration (DVCPRO HD and the
AVC-Intra 100: about 5 minutes; DVCPRO50
and the AVC-Intra 50: about 10 minutes;
DVCPRO or for DV: about 20 minutes) or
when a one-time recording extends over
more than one P2 card, the recording
concerned will automatically be undertaken
as a separate clip. At this time, each clip will
be provided with its own COUNT value.