Entering The User Bits - Panasonic AG-HPX250 Operating Instructions Manual

Entering the user bits

The user bits allow information, including memos
that use up to eight-digit hexadecimal numbers
(date and time), to be recorded in the Subcode
area.
RESET button
COUNTER button
MENU button
Operation lever
1
Open the setting menu RECORDING SETUP
screen and set the menu option UB MODE
to USER.
• For details on menu operation, refer to "Using
the setup menus" (Page 28 of Vol. 1).
• You can also use the corresponding buttons
on the remote control. For details, see
"Description of parts" (Remote control).
(Page 19 of Vol. 1)
2
Select CHANGE for UB PRESET on the
setting menu RECORDING SETUP screen
and press SET on the Operation lever to
open the User's Bit setting screen.
3
Use Operation lever to set the user bits.
UB PRESET
+/- : PUSH
SEL : PUSH
PRESET : PUSH SET
PUSH MENU TO RETURN
► direction: S hifts the target (highlighted)
digit to the right.
◄ direction: S hifts the target (highlighted)
digit to the left.
▲ direction: I ncreases the highlighted number
by one.
▼ direction: D ecreases the highlighted
number by one.
SET: Confirms the set user bits.
• Pressing the RESET button while setting the
user bits will reset any user bit setting to 0.
4
Press SET on the Operation lever and
confirm the user's bit setting value and you
leave the user's bit setting screen.
If you leave the user's bit setting screen
without pressing SET on the Operation
lever, the set value is not retained.
5
Use the COUNTER button to display the UB
and confirm that the value set is displayed.
Retaining the user bits
The data set for the user bits are automatically
saved and retained even if the video camera-
recorder is turned off.
/
/
63