HikRobot SC2000E Series Quick Start Manual page 8

SC2000E Series Vision Sensor Quick Start Guide
Otherwise, there is a danger of electric shock.
● Before powering on the device, please confirm that the device is installed in good
condition, the wiring is firm, and the power supply meets the requirements.
● If the device emits smoke, odor or noise, please turn off the power and unplug the power
cord immediately, and contact the dealer or service center in time.
● It is strictly forbidden to touch any terminal of the device when operating it. Otherwise
there is a danger of electric shock.
● It is strictly forbidden for non-professional technicians to detect signals during device
operation, otherwise it may cause personal injury or device damage.
● It is strictly forbidden to maintain the device is powered on, otherwise there is a danger of
electric shock.
● Avoid aiming the image sensor at strong light (such as laser beams), otherwise the image
sensor will be damaged.
● It is forbidden to touch the image sensor directly. If it is necessary to clean, please
moisten the soft clean cloth with 75% or less alcohol and gently wipe off the dust.
● Keep clean of the device's image acquisition window. It is recommended to use cleaning
water to wipe off the dust. When the device is not in use, please add a dust cover to protect
the image acquisition window.
● If the device does not work properly, please contact your dealer or the nearest service
center. Never attempt to disassemble the device yourself. We shall not assume any
responsibility for problems caused by unauthorized repair or maintenance.
● Please dispose of the device in strict accordance with the relevant national or regional
regulations and standards to avoid environmental pollution and property damage.
Note
● Check whether the device's package is in good condition, whether there is damage,
intrusion, moisture, deformation, etc. before unpacking.
● Check the surface of the device and accessories for damage, rust, bumps, etc. when
unpacking.
● Check whether the quantity and information of the device and accessories are complete
after unpacking.
● Store and transport the device according to the storage and transport conditions of the
device, and the storage temperature and humidity should meet the requirements.
● It is strictly prohibited to transport the device in combination with items that may affect
or damage the device.
● Please read the manual and safety instructions carefully before installing the device.
● Quality requirements for installation and maintenance personnel:
○ Qualification certificate or working experience in weak current system installation and
maintenance, and relevant working experience and qualifications. Besides, the
personnel must possess the following knowledge and operation skills.
○ The basic knowledge and operation skills of low voltage wiring and low voltage
electronic circuit connection.
○ The ability to comprehend the contents of this manual.
● Do not expose the device directly to flashlights, high-frequency switch lighting devices, or
to sunlight, which may affect the performance.
2